FRONT TURN SIGNAL AND SIDE MARKER LIGHT ASSEMBLY

TM9-2320-270-20-1

FRONT TURN SIGNAL AND SIDE MARKER LIGHT ASSEMBLY

This task covers:

c. Assembly (page 4-372)

a. Removal (page 4-370)

d. Installation (page 4-374)

b. Disassembly (page 4-372)

INITIAL SETUP

Materials/Parts

Tools

Deutsch connector (two required)

Crimping tool, electrical

Gasket (two required)

connections

Gasket, side marker lamp

Knife, pocket

Lockwasher, external tooth, turn signal

Pliers, long-nose

assembly to grille guard (two required)

Remover, wire, 1.20 diameter

Lockwasher, turn signal assembly to boot

Screwdriver, cross-tip, number one

clip

Wire stripper

Loom, lacquered wire, 1/4-inch

Wrench, open-end, 3/4-inch

Tag, marking (item 18, appendix C)

Tape, electrical (Item 20, appendix C)

Personnel Required

One

ACTION

REMARKS

ITEM

LOCATION

NOTE

The steps in this task apply to either right or left turn signal and side marker light

assemblies. The right turn signal and side marker light assembly is shown.

Tag wires according to general maintenance instructions (page 4-1). Refer to

Appendix F for wire numbers and lead colors.

To change front turn lamp do steps 10 thru 12 and 29 thru 31. To change side marker

lamp do steps 18 thru 20 and 23 thru 25. It is not necessary to remove light assembly to

change lamps.

REMOVAL

a. Using pocket knife, cut tape and take

Blue lead (3)

1. Connector (1) on

off.

wire 012 (2)

b. Using wire remover, unlock pin (4) and

pull out.

Using wire remover, unlock pin (8) and

Orange lead (7)

2. Connector (5) on

pull out.

wire 001 (6)

4-370