|
|
TM9-2320-270-20-1
WARNING LIGHT - CONTINUED
lNSTALLATION CONTINUED
NOTE
FOLLOW-ON MAINTENANCE: Check operation (TM 9-2320-270-10).
TASK ENDS HERE
STOPLIGHT AND TAILLIGHT ASSEMBLY
This task covers:
c. Assembly (page 4-368)
a. Removal (page 4-366)
d. Installation (page 4-369)
b. Disassembly (page 4-368)
INITIAL SETUP
Materials/Parts
Tools
Lockwasher, stoplight and tail lamp assembly
Crimping tool
to cross member (two required)
Extension, 12-inch, 3/8-inch drive
Tag, marking (item 18, appendix C)
Handle, ratchet, 3/8-inch drive
Pliers, diagonal-cutting
Personnel Required
Remover wire, 1.20-inch diameter
Screwdriver, cross-tip, number 1
One
Screwdriver, flat-tip
Socket, deep-well, 7/16-inch
Wire stripper
ACTION
REMARKS
ITEM
LOCATION
NOTE
To change lamp, go to disassembly. it is not necessary to remove stoplight and taillight
assembly to change lamp.
REMOVAL
NOTE
Steps in this task apply to either left or right stoplight and taillight assembly. Left
stoplight and taillight assembly is shown. Tag wires according to general maintenance
instructions (page 4-1). Refer to Appendix F for wire numbers and lead colors.
4-366
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |