 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM9-2320-270-20-1
WARNING LIGHT
This task covers:
c. Assembly (page 4-364)
a. Removal (page 4-362)
d. Installation (page 4-365)
b. Disassembly (page 4-363)
INITIAL SETUP
Materials/Parts
Tools
Gasket
Screwdriver, cross-tip, number 1
Lockwasher, ground wire to roof
Screwdriver, cross-tip, number 2
Tape, electrical (item 20, appendix C)
Screwdriver, flat-tip, 1/8-inch
Personnel Required
One
ACTION
REMARKS
ITEM
LOCATION
NOTE
To change lamp go to disassembly. It is not necessary to remove warning light assembly
to change lamp.
REMOVAL
Using number 2 cross-tip screwdriver,
Three screws (3)
1. Warning light (1) to
unscrew and take out.
cab roof (2)
Lift up and tip over on its side.
Warning light (1)
2. Cab roof (2)
Unplug.
Bullet plug (5) on
3. Bullet connector (4)
lead (6)
a. Pull off tape.
Screw (9) and
4. Ground lead (7) to
b. Using number 2 cross-tip screw-
Iockwasher (10)
cab roof (2)
driver, unscrew and take off.
c. Get rid of Iockwasher (10).
Take off.
Warning light (1)
5. Cab roof (2)
a. Pull off.
Gasket (11)
6.
b. Get rid of.
4-362
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals