|
|
TM 9-2320-270-20-1
ALTERNATOR - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION CONTINUED
a. Put straightedge across pulleys (1)
Two alternator
19. Alternator pulley
and (2).
belts (3)
(1) and drive
b. Push down on one belt (3) at a time
pulley (2)
and using rule, measure movement.
Each belt should move between 3/8-
inch (9.52 millimeter ) and 5/8-inch
(15.87 millimeter). if belt moves too
much or too little, loosen screw(4)
and repeat step 18. If any belt cannot
be adjusted to correct measurement,
replace all belts.
Using 3/4-inch socket, handle, and 3/4-
Bolt (7) and
Adjusting link (5)
20.
inch box wrench, tighten.
nut (8)
to adjusting
bracket (6)
Using 3/4-inch socket, handle, and 3/4-
Screw (11) and
21.
Alternator mounting
inch box wrench, tighten.
nut (12)
bracket (9) to
alternator (10)
Screw in and tighten using 1/2-inch
New Iockwasher
Wire 128 (13)
22.
socket and handle.
(14) and screw (15)
to alternator (10)
Screw in and tighten using 3/8-inch socket
Nut (17)
Wire 278 (16) to
23.
and handle.
alternator (10)
Connect (page 4-444).
Battery ground
24.
cable
ADJUSTMENT
Turn on.
Ignition switch (18)
25.
Note voltage reading.
BATTERY gage (20)
2 6 Instrument
panel (19)
Start (TM 9-2320-270-10).
Engine
27.
Note voltage reading.
BATTERY gage (20)
28.
4-220
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |