FUEL SYSTEM - TM-9-2320-270-20-10306

TM9-2320-270-20-1

FUEL SYSTEM

This task covers:

a. Fuel Tank Draining (page 4-32)

b. Fuel System Purging (page 4-33)

INITIAL SETUP

NITIAL SETUP

Materials/Parts

Tools

Container (as required)

Compressor, reciprocating air

Handle, ratchet, 3/8-inch drive

Personnel Required

Hose assembly, rubber

Socket, 9/16-inch, 3/8-inch drive

One

Wrench, open-end, 9/16-inch

Wrench, open-end, 3/4-inch

ACTION

REMARKS

ITEM

LOCATION

FUEL TANK DRAINING

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices

permitted nearby when using fuel. Fuel burns easily and fumes are explosive. Keep

battery disconnected. Failure to observe these precautions could cause serious injury.

NOTE

When draining one tank, make sure handle on valve is pointing up (closed position).

After tank has been drained and refilled, pull handle down (open position).

There are two fuel tanks on the vehicle. Steps 1,2, and 3 can be used to drain either

fuel tank. Right fuel tank is shown.

Unscrew and take off.

Cap (2)

1. Right fuel tank (1)

Put container underneath.

Plug (3)

Using 3/8-inch ratchet handle and

socket, unscrew and take out.

c. When fuel stops draining, using 3/8-

inch ratchet handle and socket, screw

in and tighten.

d. Get rid of drained fluid (page 4-1).

4-32