ROCKER ARM AND VALVE COVER AND GASKET FOR EARLY T ENGINE

TM9-2320-270-20-1

ROCKER ARM AND VALVE COVER AND GASKET - CONTINUED

INSTALLATION CONTINUED

NOTE

FOLLOW-ON MAINTENANCE:

1. Start engine and check for leaks (TM 9-2320-270-10).

2. Install side panel and close hood (TM 9-2320-270-10).

TASK ENDS HERE

ROCKER ARM AND VALVE COVER AND GASKET FOR EARLY T ENGINE

This task covers:

d. Assembly (page 4-21)

a. Removal (page 4-18)

e. Installation (page 4-22)

b. Disassembly (page 4-20)

c. Cleaning and Inspection (page 4-20)

INITIAL SETUP

Materials/Parts Continued

Tools

Gasket, rocker arm and valve cover

Drift, brass, 1/2-inch

Wrap, tie (item 24, appendix C)

Hammer, plastic-face, medium

Pliers, retaining ring

Personnel Required

Pliers, slip-joint, straight-nose

Screwdriver, flat-tip, 1/4-inch,

One

Wrench, open-end, 9/16-inch

Equipment Condition

Materials/Parts

Right or left side of hood open and right or

Cotter pin

left side panel removed

Gasket, breather

(TM 9-2320-270-10).

ACTION

REMARKS

ITEM

LOCATION

REMOVAL

Using screwdriver, unscrew part way.

Screw (2)

1. Oil breather hose

clamp (1)

Pull off.

Oil breather

2. Oil breather

Leave clamp on hose.

hose (4)

housing (3)

a. Using slip-joint pliers, cut off.

Tie wrap (5)

3. Oil breather

b. Get rid of.

hose (4)

4-18