|
|
TM 9-2320-270-20-1
TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
58. EXCESSIVE AIR PRESSURE.
Step 1.
Open right side of hood and remove side panel (TM 9-2320-270-10). Check
air compressor governor (1) if it is working (NO OR LOW AIR PRESSURE
(step 6)) (page 3-129).
If governor does not work, replace (page 4-851).
WARNING
Be sure to wear safety goggles or lenses when venting air lines. Compressed air and
particles amoved by compressed air can cause damage to your eyes.
Step 2.
Install side panel and close right side of hood (TM 9-2320-270-10). Check
safety release valve (2), on top of reservoir tank (3), for operation by pulling
exposed stem (4) to open valve and then releasing. Air should be released when
stem is pulled and stopped when stem is released.
If safety valve does not work, replace (page 4-714).
TA239720
3-133
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |