 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
REAR-REAR AXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
80.
Differential
Ring gear (2) Mount dial indicator at side of gear (2)
carrier (1)
to set bearing preload.
81.
Two bearing
Four screws (4)
Using 13/16-inch socket and handle
with
caps (3)
3/4-inch drive, unscrew only enough to
note end play on indicator.
82.
Differential
Ring gear (2) a.
While gear (2) is held at zero end
carrier (1)
play, and before loading bearings,
check runout by turning ring gear (2).
b.
If runout is more than 0.008-inch
(0.20-mm), remove differential
assembly and check for cause.
83.
Two bearing
Four screws (4)
a.
Tighten to 150-160 ft-lb (203-
217
caps (3)
N m) of torque using 13116-inch socket
and torque wrench with 1/2-inch drive.
b.
Recheck backlash, step 79.
84.
Two adjuster
Put in.
locks (5)
85.
Two adjuster
Two new cottera.
Put in.
locks (5)
pins (6) b.
Using angle-nose slip-joint pliers,
TA238567
2-926
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals