|
|
TM 9-2320-269-34-1
REAR-REAR AXLE DIFFERENTIAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
56.
Differential
Pinion and cage
Place in position.
carrier (1)
assembly (2) and
shims (3)
57.
Pinion and cage
Six screws (4) Screw in, and tighen to 100-120 ft-lb
assembly (2)
(135-163 N m) of torque, using 13/16-
inch socket and torque wrench with 3/4-
inch drive.
NOTE
Step 58 will establish pinion nominal dimension. This dimension is the distance of drom the face or finished end of
the installed pinion gear to the centerline of the ring gear.
58.
Differential
Pinion gear (5) a.
Using step plate and clamp assembly
carrier (1)
from pinion setting gage set, attach
it to carrier (1), locating step plate
screw over center of gear (5).
b.
Install another step plate under clamp
screw, and tighten screw to hold plate
securely in place.
Step plates are necessary to project
the face of pinion gear so It can be
measured.
c.
Be sure lugs on step plate straddle the
bearing staking marks on end of pinion
gear (5).
d.
Install assembled setting gage and discs
(number D-2) in carrier (1) bearing
bores.
Make sure bearing bores are clean
and free of nicks and burrs.
e.
Adjust micrometer caliper so it is di-
rectly over end and at a 900 angle
to step plate.
f.
Run micrometer thimble down to mea-
sure distance between center of ring
gear step plate.
2-920
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |