FORWARD RANGE CLUTCH INSTALLATION - CONTINUED

TM 9-2320-269-34-1

TRANSMISSION SUBASSEMBLIES - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

FORWARD RANGE CLUTCH INSTALLATION - CONTINUED

112.

Continued

b. Continued

When correctly placed, the front of

forward clutch housing will be about

1/2 inch (12 mm) below forward

edge of power takeoff opening in

housing.

WARNING

Be sure to wear safety goggles or lenses when using compressed air.

Compressed air and

particles moved by compressed air can cause damage to your eyes.

c. Using air compressor, apply short bursts

of air, 45 psi maximum (310 kPa), to

fourth clutch supply po rt.

If forward clutch does not move,

it is seated correctly.

d. If clutch (1) is not seated, do steps

a and b again.

OIL PUMP AND FRONT SUPPORT INSTALLATION

113.

Transmission

New front support

Put into place.

housing (2)

gasket (3)

114.

Oil pump and front

New gasket (5)

a. Put on.

support assembly (4)

b. Grease with oil soluble grease.

115.

Race (6) and

a. Put on.

bearing (7)

b. Apply oil soluble gre ase to keep in

place.

TA238419

2-684