|
|
TM 9-2320-269-34-1
FRONT WIRING HARNESS
This task covers:
a. Removal (page 2-462)
c.
Inspection/Replacement (page 2-466)
b. Cleaning (page 2-466)
d.
Installation (page 2-467)
INITIAL SETUP
Tools
Personnel Required
Handle, ratchet, 318-inch drive
One
Screwdriver, flat-tip, 1/4-inch
Socket, 3/8-inch drive, 7116-inch
Equipment Condition
Socket, 3/8-inch drive, 112-inch
Wrench, open-end, 3/8-inch
Battery ground cables disconnected
Wrench, open-end, 7/16-inch
(TM 9-2320-269-20-1).
Wrench, open-end, 112-inch
Left and right side hood panels raised
(TM 9-2320-269-20-1).
Materials/Parts
Lockwasher
Rags, wiping (item 42, appendix B)
Solvent, drycleaning (item 49, appendix B)
Tag, marking (item 50, appendix B)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
When taking electrical connectors apart, make sure wires on both sides of connectors are marked with tags. This will
help in locating the right wires and connectors during installation.
1.
Chassis harness
Bulkhead plug (2)
a.
Using 1/4-inch flat-tip screwdriver,
plug (1)
disengage tab at bottom of plug (2).
b. Pull apart.
2.
Washer bottle
Connector (4)
Pull off.
terminal (3)
3.
Left headlight
Connector (6)
Pull apart.
lead (5)
4.
Left turn signal
Connector (8)
a.
Pull apart.
terminal (7)
b.
Pull lead and connector out through
grommet in fender wall.
2-462
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |