|
|
TM 9-2320-269-34-1
GOVERNOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY/ADJUSTMENT - CONTINUED
NOTE
The cylinder nuts are waved on the bottom and must be turned until they seat to insure not working loose
during operation.
71.
Two flyweight
Two cylinder
Using governor spring adjusting wrench and
posts (8)
nuts (10)
depth micrometer, screw on nuts (10) until
post (8) protrusion is not more than 0.001-
inch (2.5 mm) and is the same on both
sides.
NOTE
Before installing bumpers, coat them with clean engine oil.
72.
Governor
Retainer (11) and
a.
Put retainer (11) over flyweight
flyweight (1)
four bumpers (12)
tabs (13).
b. Put bumpers (11) in against flyweight
tabs (13).
73.
Governor hub (14)
Put through flyweight (1), between
bumpers (12).
Tap into place with plastic-face
hammer if needed.
2-349
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |