|
|
TM 9-2320-269-34-1
ROCKER ARMS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT/REPAIR - CONTINUED
11.
All threaded parts
Look for stripped, gouged, and damaged
threads.
ASSEMBLY
12.
Rocker arm shaft (1)
Oil supply
a. Line up oil holes.
bracket (2)
b. Using arbor press, press on until oil
holes are indexed.
13.
Oil supply
New lockwasher (3)
Screw in, and tighten using 7/16-inch
bracket (2)
and screw (4)
socket and ratchet handle with 3/8-inch
drive.
14.
Eight rocker arms
Eight adjusting
Using 3/16-inch flat-tip screwdriver, screw
(5), (6), (7),
screws (9)
in from bottom, until about 1/2 inch
and (8)
(12.7 mm) shows above the top of arms.
15.
Eight adjusting Eight nuts (10)
Screw on two or three turns.
screws (9)
16.
Rocker arm
Eight rocker arms
a. With arms (5), (6), (7), and (8) and
shaft (1)
(5), (6), (7), and
brackets (11) in proper order, and oil
(8) and brackets (11)
feed holes facing down, slide on using
plastic-face hammer if needed.
Oil feed holes in right rocker arm
shaft assembly will be toward the
rear, and oil feed holes in the left
rocker arm shaft assembly will be
toward the front of the engine.
b. Using spring and two cotter pins, hold
assembly together for installation.
INSTALLATION
17 .
Cylinder head (12)
Eight valve caps
a. Place in position.
(13) and rocker arm
b. Take off cotter pins and spring.
assembly (14)
2-168
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |