|
|
TM 9-2320-289-34.1
FLYWHEEL HOUSING - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
3.
Flywheel housing (1)
Two screws (2)
Using 13/16-Inch socket and
ratchet handle
and washers (3)
with 112-inch drive, unscrew and take out.
4.
Cylinder block (4)
Flywheel housing (1) a.
Using hoist, lift off and set
on clean
and gasket (5)
workbench.
It may be necessary to tap
housing
loose using plastic-face hammer.
b.
Get rid of gasket (5).
c.
Take off lifting equipment.
DISASSEMBLY
NOTE
Do not take out dowel pins unless they are damaged.
5.
Two dowel pins (6)
a.
Using pliers wrench, pull out.
b.
Get rid of.
CLEANING
NOTE
For more Information on how to clean parts, go to General Maintenance Instructions (page 2-46).
WARNING
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when using
solvent. Failure to observe these precautions could cause serious injury or death.
6.
All metal parts
a.
Clean In drycleaning solvent.
b.
Wipe dry with clean, dry rags.
INSPECTION/REPLACEMENT
NOTE
For more Information on how to Inspect parts, go to General Maintenance Instructions (page 2-46),
Replace damaged or defective parts as necessary.
2-138
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |