|
|
TM 9-2320-269-34-1
CRANKSHAFT AND MAIN BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
24.
Cylinder block (1)
Four upper bearing
a.
Using clean, dry rags, wipe away any
shells (2) and upper
dirt or dust on bearing bores, shells
thrust flange (3)
(2), and flange (3).
b.
Apply clean engine oil to block bores
and both sides of shells (2) and
flange (3).
c.
Roll shells (2) and flange (3) into
position, tang last, so that tangs
engage and oil holes line up.
25.
Rear main bearing
Four lower bearing
a.
Using clean, dry rags, wipe away any
cap (4) and four
shells (6) and thrust
dirt or dust on caps (4 ) and (5), shells
main bearing
flange (7)
(6), and flange (7).
caps (5)
b.
Apply clean engine oil to parts.
c.
Roll shells (6) and flange (7) into
position, tang last, so tangs engage.
26.
Cylinder block (1)
Crankshaft (8)
a.
Apply clean engine oil to journals.
b.
Using lifting sling and hoist, and
turning as necessary to clear sides of
block, lower into position.
TA237985
2-123
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |