|
|
TM 9-2320-269-34-1
CYLINDER HEADS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
23.
Cylinder head (1)
Intake and
Install (page 2-158).
exhaust valves
INSTALLATION
24. Cylinder block (4)
New gasket (5)
Put on over dowels.
25.
Cylinder head (1)
a.
Attach lifting sling.
b.
Using hoist, lift and place in position
over dowels.
26.
Four washers (6)
Screw in until snug.
and screws (7)
27.
Cylinder head (1)
Two screws (8)
Screw in until snug.
28
Five washers (9)
Screw in until snug.
and screws (10)
29.
Three washers (11)
Screw in until snug.
and screws (12)
30.
Four washers (13)
Screw in until snug.
and screws (14)
31.
Eighteen screws
Using 314-inch socket, 10-inch extension,
(7), (8), 10), (12),
1/2-inch 12-point socket, and torque
and (14)
wrench with 112-inch drive, tighten in
sequence shown below to 142 - 149 ft-lb
(105 - 110 N m) of torque.
TA237976
2-111
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |