Click here to make tpub.com your Home Page

Page Title: Section IV. REPAIR OF BATTERY POWER SUPPLY PP-6607/ VVG-1 (A78)
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-1240-369-34
(4) Lubricate PFN gasket (30) by applying a
b. Inspect for PFN all circuit cards, and all modules
thin. Uniform, film of grease. MIL-G-4343, to the high
for corrosion; check all screws for worn threads check all
point on the bead of the gasket. Do not apply so much
gaskets for deterioration; and check all machined
grease that it fills the grooves on either side of the bead.
surfaces for conditions that may prevent alinement with
Apply by hand to both sides of the gasket.
mating parts.
c. Check electrical wiring for chafed electrical
(5) Install new PFN by performing steps (1)
thru (3) in reverse order.
wiring for chafed or broken wires and bad solder
connections.
d. Inspect machined sealing surfaces for surfaces
3-6. Inspection of Power Supply Control Unit (A77).
for debris or excessive lubricant that may prevent proper
a. Inspect the general condition of all parts. Check
sealing.
for wear or other conditions indicating deterioration.
Section IV. REPAIR OF BATTERY POWER SUPPLY PP-6607/ VVG-1 (A78)
(1) Remove 10 screws (1), 10 washers (2),
3-7. Disassembly of Battery Power Supply Unit (A78)
access cover (3) and gasket (4). Inspect screws and
The  battery power  supply unit  is  to  be
washers for damage and replace as necessary.
disassembled only to the point where the damaged
(2) Lubricate new gasket (41 by applying a
components can be removed and replaced.  During
thin, uniform, film of grease. MIL-G-4343, to the high
disassembly.  it is recommended that disassembled
point on the bead of the gasket. Do not apply so much
items be indexed in order of removal.  Assembly can
grease that it fills the grooves on either side of the bead.
then be accomplished by replacing items in reverse
Apply by hand to rubber insert on both sides of gasket.
index order. After any repair. the battery power supply
(3) Install new gasket in the reverse order of
unit must be purged with dry nitrogen gas in accordance
step (1).
with TM 9-2350-230-12.
a. Replacement of Gasket (see fig. 3-3).
3-7

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business