BALLISTICS DRIVE REMOVAL (CONT) - TM-9-1220-231-34-P0038

TM 9-1220-231-34&P

4-4.

BALLISTICS DRIVE REMOVAL (CONT)

Step

Procedure

Be careful when removing ballistics drive, it is heavy

and hard to handle. Do not drop as it may hurt

someone or damage equipment.

Repairman B, using fabricated Allen wrench, loosen, but do not remove eight screws (1).

Repairman A holds ballistics drive, Repairman B removes eight screws (1) and eight

Repairmen A and B, using pry bar, carefully pry and lower ballistics drive from turret

roof.

Repairman A, inside vehicle, carefully hand ballistics drive through loader's hatch to

Repairman B outside vehicle.

Using flat tip screwdriver, check that three screws (3) are tight and not missing. If loose,

tighten and tell your supervisor. If missing send ballistic drive to depot for repair.

END OF TASK

Vol II

4-6