BALLISTICS DRIVE REMOVAL (CONT) - TM-9-1220-231-34-P0037

TM 9-1220-231-34&P

4-4.

BALLISTICS DRIVE REMOVAL (CONT)

Using 9/16" box end wrench, remove two screws (1), two lockwashers (2), and two flat

washers (3) holding temperature compensating rod and bracket (4) to turret pad (5).

Be careful when using pry bar. Damage to two pins (6)

may result.

Using pry bar, remove bracket (7) from turret pad (5).

NOTE

Do steps 3 and 4 only if temperature compensating rod

(4) is being removed for repair.

Using 3/4" open end wrench, loosen two screws (8). Using wire cutter, remove wire seal

(9) from adjuster (10).

Using 1-1/16" wrench, remove adjuster (10) from ballistics drive (11).

GO TO FRAME 4

4-5

Vol II