|
|
TM 9-1 220-220-34
Section 5. DRIVE CONNECTOR
4-12.
DRIVE CONNECTOR MAINTENANCE PROCEDURES INDEX
Task
Reference (para)
Removal
Para 4-10, frame 1
Disassembly
4-13
Assembly
4-14
Installation
Para 4-11, frame 1
4-13.
DRIVE CONNECTOR DISASSEMBLY
TOOLS:
050 allen wrench
2 3/16 pin spanner wrench
PERSONNEL:
One
EQUIPMENT CONDITION:
Drive connector on work bench
PRELIMINARY PROCEDURE: Remove drive connector (para 4-10, frame 1)
FRAME
Step
Procedure
1.
Unscrew cap screw (1) and remove cap screw (1) and lockwasher (2).
2.
Loosen two setscrews (3) using .050 allen wrench.
3.
Remove pillow block cap (4) from connector (5), using 2 3/16 pin spanner wrench.
4.
Remove cap screw (6), lockwasher (7) and flatwasher (8).
5.
Carefully press out seal (9), bearings (10), seals (11 and 12), and stud (13). Discard seals
if damaged.
6.
Remove disks (14) by tightening setscrews (3), using .050 allen wrench.
7.
Discard disks (14) and remove setscrews (3).
END OF TASK
Para 4-12 Vol II
4-46
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |