Touch-up

TM 9-1025-212-23&P

B-2

b. Functional Group. Column 2 lists the item names of parts

and assemblies on which maintenance is authorized.

(5) Touch-up. TO spot paint scratched or blistered surfaces.

c. Maintenance Function. Column 3 lists the 13 maintenance

functions defined in B-2 above. Capital letters are inserted under ap-

(6) Mark. To restore obliterated identification.

propriate maintenance functions, on line with each functional group,

to indicate the lowest level of maintenance authorized to perform

d. Install. To emplace, seat, or fix into position an item in a

that function. Symbols used and the maintenance category each re-

manner to allow the proper functioning of the equipment; also to as-

presents are as follows:

semble one component of an end item with another.

Explanation

Symbol

e. Adjust. To maintain within prescribed limits by bringing into

C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Operator/Crew

proper or exact position, or by setting the operating characteristics

to the specified parameters.

O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Organizational

F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Direct Support

f. Renovate. To restore item to serviceable condition.

d. Tools and Equipment. Column 4 lists the special tools by

(1) Paint. To repaint as required.

item number specified in appendix C, section Ill, required to perform

the maintenance function.

(2) Repair. To restore serviceability to an item by correcting

e. Remarks. Column 5 is self-explanatory.

specific damage, fault, malfunction, or failure through the application

of maintenance services or other maintenance actions.

(3) Replace. To substitute a serviceable component in a

manner to allow the proper functioning of equipment.

a. Group Number. Column 1 lists the group numbers, the pur-

pose of which is to identify components and assemblies with the

next higher assembly.