 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-1520-238-S
j. Install Left and Right Wing Out
b
g. Install Stowing Kit Wing Cradles.
oard (Lower) Tiedown Straps.
Install left and right cradles as shown.
b
Snap flat hook ends of stowing kit out
Tighten three cradle turnlock studs in
oard straps into trailing edge support
mating fuselage holes.
outboard holes. Snap opposite hook ends
into wing cradle holes (fig. 2-9).
h. Mount Wings in Stowed Positions.
k. Install Left Wing Inboard (Upper)
Tiedown Strap. Snap flat hook end of
stowing kit left inboard strap into shackle
d
(D-26) attached to fuselage upper han
CAUTION
i le. Snap opposite hook end into left trail
ng edge support inboard hole (fig. 2-9).
l. Install Right Wing Inboard (Upper)
Pitot tube can be seriously dam
a
Tiedown Strap. Snap hook end of
ged if it contacts a landing gear
stowing kit right inboard strap in right
pivot fitting or other solid surface.
trailing edge support inboard hole.
Use extreme care to clear pitot tube
Mount opposite fitting end to upper fuse
l
when positioning wing on fuselage
age. Use installed fuselage tiedown
side.
screw to mount strap fitting (fig. 2-9).
Fit each wing in its cradle with trailing
m. Tighten Tiedown Straps. Adjust four
edge up and root end aft. Aline wing root
tiedown straps to remove all strap slack
bracket on forward mounting holes in fu
s
and fully seat both trailing edge supports
elage then mount brackets to fuselage
holes. Use wing forward mounting bolts
and washers. Torque upper forward bolts
NOTE
to 220 Foot Pounds, and lower forward
bolts to 90 Foot Pounds.
When properly tightened, it will not be
possible to move trailing edge supports
in any direction.
i. Install Trailing Edge Supports.
2-11.16 Install Fly Away Covers.
Install stowing kit left and right trailing
TM 1 1520 238 23
edge supports (fig. 2-9).
Change 8
2-16.1/(2-16.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals