Figure 2-68. Gyroscopic reference unit power cable removal.

TM 5-6675-250-34

Table 2-1. Troubleshooting - Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

Figure 2-68. Gyroscopic reference unit power cable removal.

Step 5. Check for defective ECU.

Replace existing ECU with an ECU that is operable, by disconnecting and connecting

Figure 2-69. Disconnecting power cables.

If the system operates correctly with the new ECU, report the bad ECU to the next

higher level of maintenance.

12. BRAKE ON INDICATOR FAILS TO EXTINGUISH FOLLOWING 90-SECOND BRAKING PERIOD

Step 1. Inspect printed circuit board for evidence of damage or failed components.

a. Loosen the eight captive screws and lift the electronic control panel assembly from the case (fig. 2-70)

Change 1