Figure 2-29. Removal of MODE SELECT switch or panel illumination control.

TM 5-6675-250-34

Table 2-1. Troubleshooting-- Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

TS 006268

Figure 2-29. Removal of MODE SELECT switch or panel illumination control.

(8). Remove the attaching parts securing switch or control to the panel assembly and remove switch.

(9). Install new switch or control in panel assembly and secure with attaching parts. Connect and

solder electrical leads to switch in accordance with the identificaiton tags on the electrical leads.

CAUTION

To avoid damaging the electrical connectors, alternate tightening each of the two screws during assembly.

(10). Install printed circuit board, but do not tighten mounting screws. Connset the two electrical

connectors and secure by tightening two screws. Fasten ten screws that secure printed circuit

board to mounting brackets.

(11). Place edge-lighted panel over connector, seat properly and secure with five mounting screws.

(12). Install BIAS control locking knob and BIAS knob on switch shaft. Secure BIAS knob by

tightening setscrews.

(13). Install TEST SELECT knob on shaft with pointer at source voltage position. Install MODE

SELECT knob on shaft with pointer at GC position. Secure each knob by tightening setscrews.

(14). Install electronic control panel assembly in case and secure with light captive screws.

Step 2. Check for defective edge-lighted panel.

Replace the edge-lighted panel as follows: (fig. 2-30).

a. Place MODE SELECT switch to GC position.

b. Place TEST SELECT switch to SOURCE VOLTAGE position.

2-22