SOLVENT FILTERING DISPENSER.

TM 5-6640-213-14

a. Clean all parts throughly with a sponge, hot water and a

nonabrasive powdered cleanser.

b. Rinse all parts thoroughly with hot tap water and then with

distilled water. Allow all parts to air-dry throughly; do not wipe

dry. Compressed air may be used to remove traces of moisture.

SOLVENT FILTERING DISPENSER.

3-11.

a, Cleaning Parts. Wash the parts of the filter holder in mild

detergent, rinse thoroughly and air-dry to minimize particulate

b. Aligning Parts. When the holder is assembled, the cover is

loaded with a flat teflon gasket, a metal support screen, a Millipore

filter, another metal support screen, and another flat teflon gasket.

The cover is fitted to the uptake tube, and the delivery tube is

aligned with the pressure hole on the front of the neoprene bulb.

3-12. WATER DETECTOR KIT, AUTOMOTIVE-AVIATION FUEL.

Never leave the light switch in the ON position if

the light has not come on. The batteries can be

destroyed or rendered incapable of sustaining a

recharge.

a. Checking Battery Charge. Push the light switch down and

outward at the same time and hold for 3 seconds. Release pressure on

the switch button slowly. If the light does not come on, repeat the

procedure. If the light does not operate after the second attempt,

recharge the batteries.

b. Recharging Battery. To recharge a battery, remove it from the

instrument and place it in the standard recharger, Model J-330. The

recharger requires a 110-volt, 60 Hz, power source.

NOTE

Although the battery cannot be overcharged, do not

allow it to remain in the recharger for more than

two weeks without use.

Replacing the Ultraviolet Tube. To replace the ultraviolet

tube,unmscrew the four roundhead machine screws from the bottom of

the unit to allow removal of the entire bottom half of the assembly.

Pull the metal reflector shield out of its slot to expose the tube.

Remove the tube by grasping both ends at the same time and rotating

the entire tube in either direction, one-quarter turn. Lift the tube

from its holder. Install the new tube by reversing the above proced-

ure. Refer to TM 5-6330-216-12 for complete maintenance procedure on

the Water Detector Kit.