Event Printer Setup (Ref. SAIG)

TM 5-6350-275-24&P

Event Printer Setup (Ref. SAIG)

When installing a new printer, or replacing a defective one, the internal printer configuration parameters

must be properly set. (Refer to the SAIG printer manual in Appendix E) These internal parameters must match

the [SYS]<CONVERSADAQ>PRINTERCONFIG. SYS file on the B39. A typical example of this file is shown

below. If unsure of your site specific parameters contact the System Administrator for a print out of this data

file. This file may only be viewed from the COMMAND LINE using the C C F (Create Configuration File)

command for a S (Serial) device type.

[SYS]<CONVERSADAQ> PRINTERCONFIG.SYS (Typical)

[Data bits (5, 6, 7, or 8: default = 7)]

[Parity (none, even, odd, 0, or 1; default = 0)]

[Baud Rate (default = 9600)]

2400

[Stop bits (1 or 2; default = 1)]

[Transmit time out (number of seconds; default = wait forever)]

no time out

[New line mapping mode (binary, CR, or CR/LF; default = CR/LF)]

cr/lf

[Line control (none, XON/XOFF, CTS or both; default = XON/XOFF)]

Xon/Xoff

[Tab expansion (default = 8)]

[Number of characters per line (default = 132)]

132

[Translation file (default = none)]

[End of transmission character (None, CR, CR/LF, or FF;Def = CR/LF)]

cr/If

PRINTER SERIAL PARAMETERS (Typical)

Serial I F

Parity

None

Serial I F

Serial Data 7 8 Bits

8 Bits

Serial I F

Protocol

X-ON/X-OFF

Serial I F

Busy Line

DTR

Serial I F

Baud Rate

2400 BPS

Serial I F

DSR Signal

Invalid

Serial I F

DTR Signal

Ready on Power UP

Serial I F

Busy Time

200ms

E-55