REPLACE RADC ENCLOSURE TAMPER SWITCH

TM 5-6350-275-24&P

3-61. REPLACE RADC ENCLOSURE TAMPER SWITCH. (Figure 3-40).

This task consists of:

a. Remove

b. Install

INITIAL SETUP

Equipment Condition:

General Safety Instructions:

Enclosure cover removed

Remove all jewelry while working

on equipment.

Tools:

Screwdriver, Flat tip (Item 6, App B)

Wear ESD wriststrap while

working on equipment.

Materials/Parts:

Tamper switch

WARNING

Shut off power source before attempting to disconnect, service, or connect wires

or cables. Failure to do so may result in serious injury or death.

a. Removal

(1) Remove the two slip-on terminal lugs (4) from the tamper switch (3).

(2) Using a flat tip screwdriver remove the two screws (6) and washers (5) holding the tamper switch (3) to

enclosure mount.

b. Installation

(1) Align the tamper switch (3) up with enclosure mount and secure with two screws (6) and washers (5).

(2) Connect the slip-on terminal lugs to tamper switch terminals (4) common and normal open (NO).

(3) Connect AC adapter to power source.

(4) Place front access cover on enclosure and secure.

3-143