REPLACE RSM 9600 BAUD MODEM

TM 5-6350-275-24&P

3-35. REPLACE RSM 9600 BAUD MODEM. (See Figure 3-37).

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Screwdriver, Flat tip (Item 6, App B)

Remove all jewelry while working on

Equipment Condition:

equipment.

Input power removed

Materials/Parts:

Wear ESD wriststrap while handling electronic

9600 Baud Modem

assemblies.

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do

so may result in serious injury or death.

a. Removal

(1)

Turn the Modem power switch to off, located on rear of Modem (2).

(2)

Remove audio cable from telset leased line connector on rear of Modem (2).

(3)

Remove the two captive screws holding the RS232 cable to DTE connector on rear of Modem.

b. Installation

(1)

Connect the RS232 cable to DTE connector and secure with two captive screws.

(2)

Connect the audio cable to telset leased line connector.

(3)

Connect the AC power cord to AC power source.

(4)

Turn the Modem (2) power switch to on.

(5)

Set up modem. (Ref. Appendix E, page E-57).

3-113