REPLACE CENTRAL PROCESSING UNIT (CPU) EVENT PRINTER ASSEMBLY

TM 5-6350-275-24&P

3-17. REPLACE CENTRAL PROCESSING UNIT (CPU) EVENT PRINTER ASSEMBLY.

This task consists of:

a. Remove

b. Install

INITIAL SETUP:

Tools:

General Safety Instructions:

Screwdriver, Flat tip (Item 6, App B)

Remove all jewelry while working on

Materials/Parts:

equipment.

Event Printer

Equipment Condition:

Serial Interface Card removed (Para. 3-25)

WARNING

Shut off power source before attempting to disconnect, service, or connect wires or cables. Failure to do

so may result in serious injury or death.

To avoid personal injury, use an adequate number of personnel to lift or move equipment weighing over

50 pounds or oversize equipment. Observe correct lifting techniques. Failure to do so may result in

serious injury or death.

Removal

(1) Press printer power switch (10) to off position.

(2) Remove ac power cord (8) from printer assembly and remove serial interface cable (6) from printer serial

interface card connector (9).

Installation

(1) Install Serial Interface Card.

(2) Connect serial interface cable (6) to printer serial interface card connector (9).

(3) Connect ac power cord (8) to printer assembly.

(4) Press printer power switch (10) to on position.

(5) Insure printer set-up parameters are correct. (ref. Appendix E pg.E-54)

3-18. REPLACE PRINTER SERIAL INTERFACE CABLE. (Figure 3-26).