CHAPTER 2 UNIT MAINTENANCE INSTRUCTIONS

TM 5-6350-275-24&P

CHAPTER 2

UNIT MAINTENANCE INSTRUCTIONS

Section I. LUBRICATION INSTRUCTIONS

2-1. LUBRICATION. There are no lubricating procedures associated with the ICIDS equipment. The only lubricating oil

used is for preventive maintenance on the camera support hinge or mounting bracket, if applicable. This lubricating oil is

identified in Appendix D, Item 11, Expendable/Durable Items List.

Section II. REPAIR PARTS; TOOLS; SPECIAL TOOLS;

TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE);

AND SUPPORT EQUIPMENT

2-2. COMMON TOOLS AND EQUIPMENT. Refer to Appendix B, Section III, Tools and Test Equipment Requirements,

for a listing of common tools and equipment.

2-3. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. There are no special tools or equipment required for

unit maintenance of the ICIDS.

2-4. REPAIR PARTS. Refer to Appendix C, Section II, Repair Parts and Special Tools List (RPSTL) for a list of repair

parts covering unit maintenance for this equipment.

Section III. SERVICE UPON RECEIPT OF MATERIAL

2-5. INSPECTION. There are no inspection services performed at the Unit Level.

2-6. SERVICE. Not applicable.

Section IV. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)

2-7. INTRODUCTION. This section describes preventive maintenance checks and services (PMCS) which must be

performed by the unit maintenance personnel to maintain the ICIDS in operational condition. Preventive maintenance

includes cleaning and inspection procedures. Such procedures are performed as outlined by the PMCS Table 2-1 to

detect conditions which might cause the performance of the equipment to deteriorate or cause equipment failure. The

PMCS table has been provided so you can keep your equipment in good operating condition and ready for its primary

mission.

2-8. EQUIPMENT ILLUSTRATIONS. Figure 2-1 is the illustration and routing diagram showing the order in which

checks and services are performed.

2-1