RADC CAPABILITIES AND FEATURES

TM 5-6350-275-24&P

RADC CAPABILITIES AND FEATURES

STARGATE 5000 - The STARGATE 5000 processor board is housed in the interior RADC, sheet steel, NEMA 12,

tamper-protected enclosure. The board has three Auxiliary communication ports for:

Laptop computer used for configuration and diagnostics

Aux 0 used for up to 31 additional remote Ledas and keypads.

Aux 1 used for up to 16 Intelligent Access Controllers and 31 doors.

The board also has a 1200 baud MOD 2 Modem with optional interface for the Encryption Communications

Protector for communication to the PMC or RSM.

STARGATE 1000 - The STARGATE 1000 board is the same as the 5000 except it does not have an AUX 1 port

for the connection of an optional Intelligent Access Controller.

Sensors interface terminals - Sixteen pin terminals used to connect sensors or other input detections devices.

Leda flex - Supports 24 Status/Alarms input and 24 output controls, and is snapped into each RADC. The PWA

can also be housed in a separate unit that communicates with the RADC through the AUX 0 port. Each Leda can

support up to 24 sensors with 24 outputs for those sensors capable of being self-tested via the keypad from the

operator workstation. All sensors provide alarm outputs when triggered, back to the RADC via the RS485 AUX 0

Bus. Up to 31 Ledas can be multi-dropped on an RS-485 line to the RADC. Power for the Leda is provided by

the STARGATE board in the RADC.

Termination module - Provides visual indicators for up to 12 sensor inputs and controls 12 relay output driven

devices to self-test the sensors.

Data encryption system (DES) - An optional unit that is enclosed in the RADC and connected to the stargate

5000/1000 processor board.

Audio Assessment Device (AAD) - Can handle up to ten microphone inputs used to monitor sounds within a

secured area. Can be switched between intercom and audio assessment, via the keyboard, by the workstation

operator.

d. Closed Circuit Television (CCTV) System. Enables operator to perform remote surveillance using one or more

monitors. In support of intruder detection, the CCTV lets operators undertake remote surveillance of a site through one

or more monitors which display the pictures received from a network of CCTV cameras. Each monitor can be configured

to display the pictures from a particular camera at all times or from several cameras in a pre-defined sequence. The

operator may also use the workstation keyboard to select a particular camera and assign it to a monitor for a clearer

display of the secured area. The video display unit will be switched on automatically if an intrusion alarm is generated

within the secured area.

CCTV CHARACTERISTICS

Cameras: The 1/2 in. interior series camera is a rugged high resolution 1/2 in. format, solid state camera for interior

CCTV applications. The camera is equipped with back focus, which allows for equally clear video at long and short

distances.

The 2/3 in. exterior series camera is a rugged high resolution 2/3 in.

format, solid state camera for CCTV

applications. The camera is also equipped with back focus.

1-11