Table 2-3. Monitor Cabinet and Status Monitor Module Operating Procedure M-1

TM 5-6350-264-14&P-11

NAVELEX EE 181-AA-OMI-120/E121 C-7359-60-1

T.O. 31S9-2FSS9-1-11

NOTE

When assuming responsibility for attending the Monitor Cabinet(s); ensure that all ALARM

(red) lights are extinguished, that all AC POWER (white) lights are on, and that proper

operating mode (ACCESS or SECURE) is indicated on all Status Monitor Modules. Also

verify that all indicator bulbs are operable by momentarily placing each lamp test switch in

the LAMP TEST position. If lights are burned out, request responsible maintenance

personnel to replace bulbs at earliest opportunity.

Indication

Operator response

1. ALARM indicator lights (red) flashing

a. Momentarily place RESET/ACK switch on associated Status Monitor

and audible tone sounding.

Module in the ACK position.

b. If alarm is not generated during a time of prearranged opening or

securing of protected area or system test, direct security personnel to

indicated protected area (NOTE 1).

After security personnel have investigated cause of alarm, momentarily

place RESET/ACK switch in RESET position to extinguish ALARM

indicator lights.

2. MONITOR AC POWER indicator

a. Momentarily place LAMP TEST/ACKNOWLEDGE switch on Monitor

Cabinet Signal Module in ACKNOWLEDGE position.

b. If lights extinguish, inform designated personnel that ac power to Monitor

Cabinet has just been lost (NOTE 2) (NOTE 3).

If lights stay on steady state, ac power has been restored to Monitor

Cabinet.

a. Momentarily place RESET/ACK switch on associated Status Monitor

3. ACCESS indicator lights(amber)

Module in the ACK position.

flashing and audible signal device

sounding.

b. If change to ACCESS is not part of a prearranged opening of protected

area, direct security personnel to indicated protected area.

2-4