CHAPTER 2 OPERATING INSTRUCTIONS - TM-5-6350-264-14-P-110016

TM 5-6350-264-14&P-11

NAVELEX EE 181-AA-OMI-120/E121 C-7359-60-1

T.O. 31S9-2FSS9-1-11

CHAPTER 2

OPERATING INSTRUCTIONS

Section I.

OPERATING PROCEDURES

2-1.

CONTROLS AND INDICATORS. The Monitor Cabinet and Status Monitor Module controls and indicators are

shown in figure 2-1, and described in table 2-1.

2-2.

NORMAL OPERATING PROCEDURES. The Monitor Cabinet(s) are ready for operation after they have been

installed, tested, and connected to the J-SIIDS Control Unit. Operating procedures are given in tables 2-3 through 2-7.

Table 2-2 is used to select the proper procedures from these tables.

Table 2-1. Operator Controls and Indicators

Control or indicator

Function

Monitor Cabinet(s)

LAMP TEST/

When placed in the LAMP TEST position, it causes all

ACKNOWLEDGE

lamps on the signal module to light.

switch (3-position toggle)

When placed in the ACKNOWLEDGE position, it

causes the ac power monitor lamps to stop flashing

and silences the audible signal device.

MONITOR AC

When on continuously, indicates the cabinet is oper-

POWER

ating on ac power. When flashing, indicates the power

(indicating lamps)

in the cabinet has changed state either from ac to

battery, or battery to ac. When off continuously, in-

dicates the cabinet is operating on battery power.

Audible signal device

When the audible signal device is sounding, the power

has changed state either from ac to battery, or battery

to ac. This is coupled with a change in state of the

MONITOR AC POWER lamps. When the audible

alarm is sounding and there has been no change in

state of the MONITOR AC POWER lamps, this indi-

cates an alarm is being presented at the Status Monitor

Module(s).

2-1