Chapter 2 SERVICE UPON RECEIPT AND INSTALLATION

TM 5-6350-262-14/9

NAVELEX 0967-466-9090

TO 31S9-4-32-1

CHAPTER 2

SERVICE UPON RECEIPT AND INSTALLATION

Section I. SERVICE UPON RECEIPT OF MATERIAL

Check the equipment against the packing

2-1.

Unpacking

slip to see if the shipment is complete. Report all

There are no special instructions for unpacking the

discrepancies in accordance with paragraph 1-2.

status module and alarm module from their shipping

cartons. It is only necessary to observe the usual

Check to see whether the equipment has

precautions and requirements associated with handling

been modified. (Equipment which has been modified

of precision electronic equipment.

will have the MWO number on the top panel, near the

nomenclature plate.) Check also to see whether all

2-2.

Checking Unpacked Equipment

currently applicable MWO's have been applied.

Inspect the equipment for damage

(Current MWO's applicable to the equipment are listed

incurred during shipment. If the equipment has been

in USASA PAM 310-6 or DA PAM 310-7 as applicable.)

damaged, report the damage on DD Form 6 (para. 1-2).

Section II. INSTALLATION INSTRUCTIONS

Remove four 6-32 flat head screws from

2-3.

Tools, Test Equipment, and Materials

each of the mounting hole covers, in the module rack of

Required for Installation

the Monitor Cabinet, and remove the covers. Retain

The only hand tool necessary for installing the status

screws for installation of status and alarm modules.

unit and alarm unit into the Monitor Cabinet is a

commercial slot-type screwdriver.

This tool will

Attach a Data Receiver to each of the

normally be provided in the tool kit, TK 105G, Federal

Status and/or Alarm Modules to be installed if used in

Stock No. 5810-610-8177. There are no special tools,

conjunction with the Data Transmission Link. Make

test equipment, or materials required for installation.

certain the connectors are properly mated and the four

captive screws are tight.

2-4

Installation Instructions (see fig. 2-1)

Unlock and open the Monitor Cabinet

Install the Status and/or Alarm Modules

door.

using four 6-32 flat head screws, making certain the

connectors are properly mated.

2-1