Figure 2-5. Installing SPU Cover on Chassis.

TM 5-6350-262-14/4

Figure 2-5. Installing SPU Cover on Chassis.

(3)

Remove cover from EOL Module and disconnect one wire; this should cause tamper alarm.

(4)

Reconnect wire to EOL Module terminal.

(5)

Short the two EOL Module terminals; this should cause tamper alarm.

(6)

Remove short across EOL Module terminals.

Caution. Do not tighten EOL Module fastener to the point of deforming cover or can. This could cause a short,

and result in a continuous tamper alarm output

(7) Reinstall cover on EOL Module and secure.

(8) Loosen SPU cover crews and partially remove cover; tamper alarm should occur when

2-8