CHAPTER 5 ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

CHAPTER 5

ORGANIZATIONAL MAINTENANCE INSTRUCTIONS

Section I. TOOLS AND EQUIPMENT

5-1.

Common Tools.

5-2. Special Tools and Equipment

No special tools and equipment are required for

Refer to table 2-1 for list of tools and equipment.

organizational maintenance of the monitor cabinet(s).

Section II. REPAINTING AND REFINISHING INSTRUCTIONS

5-3. General

The monitor cabinet(s) metal surfaces are primed

with zinc chromate primer, specification number MIL-P-

8585, and finished with gray vinyl paint, Federal

Metal surfaces of the monitor cabinet(s) are painted

Standard 595 color chip 26492. Use only these paints

with a very durable undercoat and finish paint. Under

for paint touchup and repainting. Refer to SB 11-573,

normal conditions the paint will permanently remain on

Painting and Preservation Supplies Available for Field

the surfaces and will require no retouching or repainting.

Use for Electronics Command Equipment.

However the paint may become chipped or worn away

from accidental causes, such as being bumped by a

5-5. Procedure

sharp object, or being subjected to abrasive damage of

various types. If such damage occurs, the damaged

Instructions for touchup painting and repainting are

area should be retouched, or repainted, both for

contained in TB 746-10, Field Instructions for Painting

appearance and to protect the steel case from corrosion

and Preserving Electronics Command Equipment. Care

(such as by a salt air atmosphere).

of painting equipment is covered in TM 9-213, Painting

5-4. Paint to be Used

Instructions for Field Use.

Section III. PREVENTIVE MAINTENANCE CHECKS AND SERVICES

5-6. General

all deficiencies together with the corrective action taken

on DA Form 2404.

The monitor cabinet(s) will require a minimum of

5-7. Cleaning

organizational maintenance since the J-SIIDS must be

kept in continuous operation. To insure that it is

maintained in a condition to give peak performance, it

Cleaning of the monitor cabinet(s) by organizational

must be inspected systematically so that physical

level personnel is limited to the exterior surfaces. Use a

defects may be discovered and corrected before they

mild solution of warm water and liquid soap to clean

result in damage or failure. Defects discovered during

housing and cover parts. After cleaning rinse parts with

operation of the unit will be noted for future correction to

cold water to remove any soap solution and dry

be made as soon as operation has ceased. Stop

thoroughly.

operation immediately if a deficiency is noted during

operation which would damage the equipment. Record

5-1