Crankshaft Disassembly (fig.7-50) cont'd

(12) insert shaft into hole of two speed gear with the

shaft bushings (11) Crankshaft (12) and the two speed

gear (13) may come out with cover. To remove shaft and

smaller gear towards the inside of gear box or towards

cover end. The inside end of shaft is the one that has the

gear, pull them out of the crankshaft housing (6)

bushings.

two detent grooves. Slide gear so that its groove pin hole

aligns with hole in shaft. Insert groove pin (14) in hole of

gear hub and shaft.

g. To remove two-speed gear (3) from crankshaft

i. To remove shaft bushings (11) use a rod to gently

(12) ,remove groove pin, 3/8 inch dia. x 1 5/ 16 Ig. (14),

tap until bushing is out of cover.

then slide two speed gear off shaft.

j. Install shaft bushing in cover in reverse order.

h. To install a two speed gear(13) on crankshaft

7-9