Click here to make tpub.com your Home Page

Page Title: Figure 8-48. Trussed rafter.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-5430-209-12
shown on figure 8-48. Install 1/2 -by 1/4 inch bolts (2)
(2) Lay deck section, numbered face down, on
top of block. Numbered face is the top or outside of the
through all boltholes in bolt channel (1, fig. 8-49), rafter
section, and deck section, leaving the chime boltholes
section.
(3) Starting at large end of deck section, place
vacant. Secure not less than eight bolts with finger-
tightened nuts to hold rafter section in place.
outer rafter section (9, fig. 8-48) on each lap seam of the
deck section. Correct position of rafter section is
1.
STRIP GASKET
10.
TENSION MEMBER (CENTER)
2.
BOLT
11.
TENSION MEMBER (INNER)
3.
RAFTER POST (OUTER)
12.
TENSION MEMBER (OUTER)
4.
RAFTER POST (INNER)
13.
RAFTER SUPPORT CLIP
5.
RAFTER HANGER
14.
RAFTER BOLT RETAINER
6.
TRUSS SUPPORT PLATE
15.
RAFTER STIFFENER
7.
RAFTER SECTION (INNER)
16.
BOLT
8.
RAFTER SECTION (MIDDLE)
17.
BOLT HOLE
9.
RAFTER SECTION (OUTER)
18.
NUT
ME 5430-209-12/8-48
Figure 8-48. Trussed rafter.
(4) Place middle rafter section (8, fig. 8-48) on
sections. Insert bolts (2) through boltholes in bolt
each lap seam so that the middle sections are alined
channel (2, fig. 8-49), rafter section, and deck section.
with and abutted against the inner ends of the outer
Secure 8 or 10 bolts with finger-tightened nuts.
8-29

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business