DEPRESERVATION - TM-43-01560139

TM 43-0156

Step

Function

Mech

Insp

DEPRESERVATION

Follow instructions given on DA Forms 2258.

Follow instructions on tags attached to the engine start controls

Unpack, inspect, and assemble components.

Fill dry-charged battery as follows:

The battery you have received with the set is charged and

dry. If the battery has been stored in a cool, dry place,

you can expect it to deliver approximately 75 percent of its

rated power when filled with electrolyte. Perform the

following steps to fill a new battery.

WARNING

If battery electrolyte is

spilled on skin or cloth-

ing, immediately wash with

cold water or a sodium bi-

carbonate solution to pre-

vent severe skin burns or

damage to clothing.

CAUTION

Avoid spilling battery elec-

trolyte on painted surfaces.

Damage to painted surfaces

may result.

a. Remove the battery cell vent caps.

b. Remove and destroy the vent plugs which seal the holes

below the vent caps.

c. Fill each cell of a dry battery with electrolyte to the

level indicated on the vent plug or cell cover.

(1) In temperate climates, use electrolyte of 1.280

specific gravity at 800F (27 ).

(2) The battery and electrolyte must be 60 (160C) or

higher and preferably below 100 (38 ) for proper

charging.

B-2-76