Louvered Radiator Openings (sides) (two).

TM 43-0156

Step

Function

Mech

Insp

(4) Secure plywood with removed bolts. Seal edges of

plywood panel with tape (7510-00-916-9659). NSN

cont

7510-00-890-9875 may be used as asubstitute.

Louvered Radiator Openings (sides) (two).

(1) Close louvers.

(2) Remove 12 bolts evenly spaced from around louvers to

secure a plywood panel.

(3) Cover louvers with barrier (8135-00-282-0565) and

5/16-inch (86-1/2 x 55-1/2) plywood panel (5530-00-

618-6955). Drill holes in location of mounting bolts that

were removed. Plywood, 3/8-inch (5530-00-618-6956)

may be used as a substitute.

(4) Secure plywood panel with removed bolts.

(5) Seal edges of plywood panel with tape (7510-00-916-

9659). NSN 7510-00-890-9875 may be used as a sub-

stltute.

Catwalk, Clevises, Exhaust Stacks, Ground Rods, Wire,

and Clamps.

(1) Secure catwalk in its raised position.

(2) Secure exhaust clamps to exhaust stacks.

(3) Secure exhaust stacks, clevises, and ground rods to

the catwalk with steel strapping (8135-00-283-0669).

Isolate the steel strapping with fiber-board. Secure

strapping with seals (8135-00-239-5293).

Slings. Coat slings with corrosion preventive compound

Bracing for Shipment.

(1) Air Filter Compartment. Place lumber (5510-00-220-

6214) (36 x 2-7/8 x 4) between air filter compartments

and the generator control cabinet.

(2) Control Cabinet. Brace the generator control cabinet

to the generator with 3-inch angle iron (9520-00-516-

5810). Bolt brace in place with existing bolts and lifting

eyes on generator.

(3) Radiator. Brace radiator to the floor with 3-inch

angle iron (9520-00-516-5810). Secure braces at a

45 angle from approximately two-thirds up on the

radiator to the floor.

Change 1

B-1-30