Connector J1 through J8 Removal and Replacement

TM 32-6110-003-24&P

(10) Install insulating strip (60) in accordance with paragraph 5-121.

(11) Install terminal board TB2 and TB3 (58) in accordance with paragraphs 5-12j.

(12) Install socket XK4 (24) in accordance with paragraph 5-12d and relay K4 (23) in accordance with

(13) Install relays K1, K2, and K3 (30) in accordance with paragraph 5-12e.

(14) Replace RFI filter assembly (6) in accordance with paragraph 5-11a and bottom cover (3) in

(15) Replace high voltage shield (5) in accordance with paragraph 5-11b and to cover (2) in accordance

o. Connector J1 through J8 Removal and Replacement. Refer to figure 5-3 and proceed as follows:

(1) Remove top cover (2) and bottom cover (3) in accordance with paragraph 5-10a.

(2) Remove the high-voltage shield (5) in accordance with paragraph 5-10b.

(3) Remove four screws (36), flat washers (37), lock washers (38), and nuts (39) that secure connector

(35) to chassis and remove connector.

(4) Pull heatshrink tubing away from connector terminals, tag and unsolder wires from connector.

(5) To replace connector, slide length of heatshrink tubing (items 7 through 11, App. D) over wires, then

solder wires to connector terminals as marked during removal. Slide heatshrink tubing over

connection and shrink.

(6) Insert connector through opening in chassis, and secure with four screws (36), flat washers (37), lock

washers (38), and nuts (39).

(7) Install high-voltage shield (5) in accordance with paragraph 5-11b.

(8) Install top cover (2) and bottom cover (3) in accordance with paragraph 5-11c.

(9) Refer to section V of this chapter.

5-31