Refer to figure
k. Screw Thread Insert Removal and Replacement.
5-9 and proceed as follows:
(1) Remove the front panel in accordance with paragraph
(2) Remove and replace the defective screw thread insert
in accordance with the procedures in paragraph 5-12ah.
(3) Replace front panel in accordance with paragraph 5-11h.
Refer to figure 5-9 and proceed as
l. Enclosure Replacement.
Slide the enclosure (6) forward, over the chassis.
Replace the two screws (3), flat washers (4), and lock
washers (5) that secure the enclosure (6) to the chassis.
Replace the nut (1) on terminal stud E3 (2).
Fastener Removal and Installation