Appendix E: INTEGRATED LIST OF MANUFACTURED ITEMS

TM 32-5865-216-24&P

INTEGRATED LIST OF MANUFACTURED ITEMS

E-1. GENERAL.

This appendix provides the replacement procedure for

the EMI/RFI gasket on the bottom cover and chassis of Tunable Coupler

CU-2293/ALQ-151(V).

This appendix can be used to facilitate repair

and maintenance in the field.

Fitting is critical to ensure an airtight closure that

meets the anti-sparking requirements of Tunable Coupler

CU-2293/ALQ-151(V).

E-2.

PARTS LIST.

Item Description

Quantity

EMI/RFI Gasket, FSCM 12881, P/N 06-0120-6044-13

7.5 ft (2286 cm)

Adhesive, FSCM 96717, RTV733

1 tube

GASKET REPLACEMENT.

To replace the bottom cover or chassis gasket, proceed as

follows:

Use the riveter kit (see maintenance allocation chart) to

remove the gasket to be replaced.

Refer to figure E-1 for the required dimensions of the

replacement gasket.

Figures E-2 and E-3 show locations for

the bottom cover and chassis gasket.

NOTE

During the following step, cut the gasket and weather seal

separately to the required length, before cutting the

aluminum center strip.

Measure and cut the gasket, weather seal, and aluminum center

strip to the required lengths (see figure E-1).

Drill the required number and size of holes in the aluminum

center strip at the specified locations.

Clean all old adhesive from the surface where the gasket is to

be installed.

Apply a continuous bead of adhesive to the surface where the

gasket is to be installed.

Place the replacement gasket in position by alining the holes

in the gasket with the holes in the bottom cover or chassis.