MAINTENANCE OF MASTER RELAY TO BULKHEAD DISCONNECT SPECIAL CABLE ASSEMBLY.

TM 9-2350-238-20-1

1 Inspect for broken, damaged, or missing

Electrical wire is a manufactured item,

refer to appendix D.

parts.

2 If damaged or missing, replace marker

Repair is by replacement of authorized

bands. Etch or stamp lead number on

parts (TM 9-2350-238-24P-1).

new band.

3 For repair of shell connectors, refer to

general maintenance, page 2-371.

For reassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

Connect plug connector (1) to low engine

1 Install low coolant warning light to bulk-

coolant warning indicator light.

head disconnect branched wiring hanress

(5) in hull through driver's compartment.

Wiring harnesses and leads are secured to

the hull and components with loop clamps,

2 Connect two shell connectors (4) to line

straps, clips, ground screws, etc. During

disconnects to aeration detector.

installation, make sure the wiring harness

or lead is secure and all hardware is tight.

3 Connect shell connector (3) to line

disconnect to circuit breaker.

4 Connect shell connector (3) to driver's

compartment dome light.

2-120. MAINTENANCE OF MASTER RELAY TO BULKHEAD DISCONNECT SPECIAL

CABLE ASSEMBLY.

a. Removal

c. Inspection/Repair

e. Installation

This task covers:

b. Disassembly

d. Reassembly

INITIAL SETUP

2-928 Driver's compartment aft cowl

removed

Materials/Parts

Electrical wire (figure D-2, appx D)

General Safety Instructions

References

TM 9-2350-238-24P-1

Failure to remove or disconnect

Equipment Conditions

batteries before removing or installing

2-640 Batteries disconnected

2-952 Driver's seat removed

any electrical wiring harness or lead

may result in injury or damaged

2-928 Driver's compartment forward cowl

removed

equipment.

2-733