 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-20-2
16-8. HOOD ADJUSTMENT (CONT)
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
(3) Coat threads of two screws (1) with
adhesive-sealant.
(4) Install bracket (2) on tow eye (4) with two
screws (1). Torque to 110 lb-ft (150 Nm).
(5) Repeat steps (1) thru (4) for other side.
(6) Remove two locknuts (5) from screws (6)
on bracket (7). Discard locknuts.
(7) Position two new locknuts (5) on screws
(6). Do not tighten locknuts.
NOTE
When bracket is properly adjusted,
hood bracket and cushion will hold
rear of hood flush with cab.
(8) Move bracket (7) to left or right and tighten
two new locknuts (5) to 23 lb-ft (16 Nm).
(9) Remove nut (8) an d lockwasher (9) from
back of cushion (10).
(10) Move cushion (10) up or down and install
new lockwasher (9) and nut (8).
(11) Repeat steps (6) thru (10) for other side.
16-28
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
|
|
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
|
Click
here for thousands of PDF manuals
