RUBBER WATERPROOF CONNECTOR
This task covers:
a. Removal (page 4-508)
b. Installation (page 4-508)
Compound, insulating (item 6, appendix C)
Pliers, diagonal cutting
To prevent possible damage to equipment, make sure circuit whose wire you are
repairing has no electricity going to it. If necessary, disconnect battery ground cable.
Slide up wire (2) until clear of
1. Connector assembly
a. Using cutting pliers, cut off as close
2. Wire (2)
to terminal (3) as possible.
b. Get rid of old terminal (3).
Using long-nose pliers, pull out.
4. Shell (1)
Push into shell (1).
5. Shell (1)