 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
REAR COVER AND OUTPUT SHAFT
This task covers:
a. Disassembly (page 2-772)
c.
Inspection/Replacement/Repair
b. Cleaning (page 2-774)
d. Assembly (page 2-776)
INITIAL SETUP
Tools
Materials/Parts
Compressor, low and first clutch
Cloth, crocus (item 7, appendix B)
Compressor, reciprocating air,
Compound, sealant, non-hardening
power driven
(item 13, appendix B)
Driftpin, brass, 3/16-inch
Grease, oil soluble (item 21, appendix B)
Goggles, safety
Packing, preformed, low clutch piston, inner
Gun, air blow
Packing, preformed, low clutch piston, outer
Hammer, ball-peen, machinist's
Pin, output shaft spring
Handle, driver
Seal, output shaft bearing
Handle, rachet, 3/8-inch drive
Solvent, drycleaning (item 49, appendix B)
Hose, air compressor
Tube, drain, rear cover assembly
Installer, dust-shield
Installer, orifice plug
Personnel Required
Installer, output shaft bearing
Installer, output shaft oil seal
One
Installer, rear bearing
Key, socket-head screw, 5/16-inch
Equipment Condition
Pliers, slip-joint
Press, arbor, hand-operated
Rear cover output shaft removed
Remover, rear bearing
Remover, seal and dust shield
Screwdriver, flat-tip, 3/8-inch
Socket, 3/8-inch drive, 7/16-inch
Socket, 3/4-inch drive, 2 1/8-inch
Wrench, torque multiplier, 3/4-inch drive,
0 - 1, 000 ft-lb. capacity
2-771
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals