TRANSMISSION OIL PUMP AND FRONT SUPPORT - CONTINUED
If bushing was not removed, skip step 21.
Front support (5)
New bushing (1)
Place joint in bushing (1) between 10
and 12 o'clock position.
Using arbor press, press in.
Bushing must be flush to 0.010-
Inch (0.25 mm) below edge of bore.
New oil seal (8)
Coat outside diameter of seal with
high temperature seal lubricant.
Using arbor press, seal installer, and
driver handle, press on.
If seal installer is not available,
install seal so spring-loaded lip is
first. Using arbor press, press
seal in to 0.010 to 0.020-Inch
(0.25 to 0.51 mm) below edge of
Coat inside of seal with high tempera-
ture seal lubricant.