TRANSMISSION ASSEMBLY - CONTINUED
INSTALLATION - CONTINUED
f. Tilt the rear of the transmission
slightly downward so the converter
will not fall out.
g. Raise and level the transmission.
h. Aline the holes in the transmission
housing with the guide studs, and the
torque converter drive studs with holes
in the flywheel.
i. Move into position.
Eight washers (3)
Screw in, and tighten using 9/16-inch
and screws (2)
socket and ratchet handle with 1/2-inch
Four washers (6)
a. Unscrew, and take out four guide studs
and screws (7)
using 3/8-inch flat-tip screwdriver.
b. Screw in, and tighten using 9/16-inch
socket and ratchet handle with 1/2-
Using 9/16-inch socket and torque
(2) and (7)
wrench with 1/2-inch drive, tighten all
screws to 26-32 ft-lb (35-43 N m) of