Table 2-1. Troubleshooting - Continued
TEST OR INSPECTION
Figure 2-15. Removal and ECU panel assembly.
b. Unfasten ten screws (fig. 2-15) securing the printed circuit board to mounting brackets and
loosen board to obtain access to electrical connectors.
To avoid damage to the electrical connectors, alternately backoff each of the two attaching screws when removing the
c. Disconnect two electrical connectors (2A2J5 and 2A2J6), by unfastening two screws at each
d. Place MODE SELECT switch to GC position (fig. 2-16).